Nike STR8-Fit Ferrule Instruction Manual

Billy Bob’s Instructions

Removal and Replacement

New Nike STR8-Fit Replacement Ferrule for the

Nike Series Adjustable Metal Sleeve

This is a simple headline

  • Nike MACHSPEED SQ
  • Nike MACHSPEED SQ BLACK
  • Nike MACHSPEED SQ BLACK SQUARE
  • Nike SQ Dymo STR8-Fit

Below is a step by step instructions for the Billy Bob Replacement Ferrule for Both the Standard and the VR STR8-FIT adaptors.

You will Not need any special tools to remove the shaft
from the Factory Aluminum Sleeve. Any conventional shaft puller can be used.

Step #1 Place Ferrule and Sleeve in Conventional Shaft Puller

Step #2 Heat the Aluminum Sleeve, use the ferrule to cushion the top half of the sleeve against the puller head, You can’t save the ferrule….

Step #4 Give it time to cool down, Remove the sleeve

Step #5 Clean out any old expoxy from the metal sleeve

Step #6 It’s our feeling that a little coning on the factory sleeve is best, for protecting the new shaft

Step #7 Insert the ferrule and sleeve and mark the area you need to abrade the shaft

Step #8 As you see the ferrule and the sleeve have a Timing mark, it can only go on one way

Step #9 Apply epoxy inside the sleeve and small area around the shaft so the ferrule will
adhere to the shaft, do not get any epoxy on the swivel collar, it must be free to move, you are gluing the ferrule to the shaft

Special Instructions on the
  • Nike VR STR8-Fit (NON-TOUR)
  • Nike VR Pro
  • Nike VR Pro Fairway Woods

The Nike VR Series has a different sleeve than the Dymo and the Machspeed It has more adjustments and the sleeve is .030 larger in Diameter. The sleeve pictured above will not sit flat on the metal sleeve without some adjustments. Instructions below will help you to make those minor adjustments.

VR collar pictured above is .030 larger you will have to enlarge the opening of the ferrule.

Reaming it out with a .435 fluted reamer You will be removing the first step and the timing mark inside the ferrule.

Slight pressure will remove the first step and timing mark

You can now install the ferrule but remember to align the timing mark with the down arrow indicating the neutral position as shown above, use a simple white maker to indicate the neutral position on the spline.

1 Down arrow is Neutral.
2 Timing Mark is Neutral on sleeve collar.
3 White marker indicates Neutral on the spine area

Leave a Reply

Your email address will not be published. Required fields are marked *


By submitting this form, you are consenting to receive marketing emails from: BillyBobs Golf, Inc, 24335 Prielipp Rd, Wildomar, CA, 92595, www.billybobgolf.com. You can revoke your consent to receive emails at any time by using the SafeUnsubscribe® link, found at the bottom of every email. Emails are serviced by Constant Contact

This site uses Akismet to reduce spam. Learn how your comment data is processed.