Callaway Loft and Lie Adapter Installation Manual

Callaway

BILLY BOB’S Loft and Lie Adaptor

Installation Instructions

Fits all New Callaway Hoseless Clubs

This Billy Bob’s loft and lie adaptor or (clock ferrule) will fit all the newer .350 hosel Callaway
clubs (VFT ERC II, Big Bertha II, Fusion, 460 X, FT5, FT 9, Ft i, FT iq and Diablo Driver (Not
the Diablo Edge or Razor Hawk it Takes FTiz Large Ferrule Adaptor) , and The New Octane it will also fit the I-MIX line of Callaway Drivers with the New Billy Bob’s I-MIX Sleeve. You must use a .335 shaft for this to work. You will need to remove all of the epoxy residue within the hosel to assure good adhesion and have room for the shaft and the ferrule to rotate to the desired position. If needed, you can use a .350 reamer to clean out the bottom portion, and a 7/16
drill or reamer to clean out the step down portion.There will be a missing mark on the ferrule (see Indicator Mark Missing Line illustration above). This is the indicator mark that will allow you to see which position you need to face the ferrule for loft and lie. Once you have achieved the proper angle, you can mark the top of the head so, when you glue the head and the shaft, you can go back to the position that you set.

Leave a Reply

Your email address will not be published. Required fields are marked *


By submitting this form, you are consenting to receive marketing emails from: BillyBobs Golf, Inc, 24335 Prielipp Rd, Wildomar, CA, 92595, www.billybobgolf.com. You can revoke your consent to receive emails at any time by using the SafeUnsubscribe® link, found at the bottom of every email. Emails are serviced by Constant Contact

This site uses Akismet to reduce spam. Learn how your comment data is processed.